Enginee.pdf

(1942 KB) Pobierz
2002 ENGINE
Lubrication - RAV4
OIL AND FILTER
INSPECTION
1.
Check engine oil quality
.
Fig. 1: Displaying Recommended Oil Viscosity
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
Check the oil for deterioration, entry of water, discoloring or thinning.
If the quality is visibly poor, replace the oil.
Oil grade:
API grade or SJ, Energy-Conserving or ILSAC multigrade engine oil is recommended. SAE
5W-30 is the best choice for your vehicle, for good fuel economy, and good starting in cold
weather
.
2.
Check engine oil level
.
After warming up the engine and then 5 minutes after the engine stop, oil level should be between the
upper and lower dot marks on the dipstick.
If low, check for leakage and add oil up to the upper dot mark.
NOTE:
Do not fill with engine oil above the upper dot mark.
3.
Remove oil pressure switch and install oil pressure gauge
.
a. Remove the oil pressure switch.
Fig. 2: Displaying Oil Pressure Switch
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Install the oil pressure gauge.
Fig. 3: Displaying Oil Pressure Gauge
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
4.
Warm up engine
.
Allow the engine to warm up to normal operating temperature.
5.
Check oil pressure
.
Fig. 4: Displaying Oil Pressure Specifications
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
6.
Remove oil pressure gauge and reinstall oil pressure switch
.
a. Remove the oil pressure gauge.
b. Apply adhesive to 2 or 3 threads of the oil pressure switch.
Adhesive: Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
c. Install the oil pressure switch.
Torque: 13 N.m (130 kgf.cm, 9 ft.lbf)
7.
Start engine and check for oil leaks
.
Fig. 5: Displaying Adhesive Proper Application To Oil Pressure Switch
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
REPLACEMENT
CAUTION:
Prolonged and repeated contact with mineral oil will result in the
removal of natural fats from the skin, leading to dryness, irritation
and dermatitis. In addition, used engine oil contains potentially
harmful contaminants which may cause skin cancer.
Exercise caution in order to minimize the length and frequency of
contact of your skin to used oil. Wear protective clothing and gloves.
Wash your skin thoroughly with soap and water, or use waterless
hand cleaner, to remove any used engine oil. Do not use gasoline,
thinners, or solvents.
In order to preserve the environment, used oil and used oil filter must
be disposed of only at designated disposal sites.
1.
Remove center engine under cover
.
2.
Drain engine oil
.
a. Remove the oil filter cap.
b. Remove the oil drain plug, and drain the oil into a container.
3.
Replace oil filter
.
a. Using SST, remove the oil filter.
SST 09228-06501
Fig. 6: Removing Oil Filter Using SST
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b. Check and clean the oil filter installation surface.
c. Check the part number of the new oil filter is as same as old one.
d. Apply clean engine oil to the gasket of a new oil filter.

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin