USB-V3-User-Guide-v02.pdf

(861 KB) Pobierz
WOOLICH RACING
USB V-3 USER GUIDE
Table of Contents
1) Introduction ................................................................................................. 3
2) Interface Description ................................................................................... 4
3) Installing USB Drivers ................................................................................... 5
4) Device Configuration.................................................................................... 6
Device Type and Firmware version .............................................................. 6
5) Device Firmware Update.............................................................................. 7
6) Connecting the Interface.............................................................................. 7
7) Engine Data Operation ................................................................................. 8
8) Read/Write Mode Operation ....................................................................... 8
9) Disconnecting the Interface ......................................................................... 8
Warranty ...................................................................................................... 9
Disclaimer ..................................................................................................... 9
Acronyms
ECU
LED
USB
WRL
WRT
Engine Control Unit
Light emitting diode
Universal Serial Bus
Woolich Racing Log
Woolich Racing Tuned
1) Introduction
This user guide covers how to install, configure and use the Woolich Racing USB v3
Interface, there after referred to simply as the Interface.
For information regarding the correct Interface model to suit your motorcycle please
visit our
Products
section of the Woolich Racing web site. Note some of the figures in
this User Guide may not be identical to yours with regards to the model of USB v3
Interface but all Interfaces operate identically.
For information on how to use the
Woolich Racing Tuned (WRT)
software please visit
our Support Centre
Video Tutorials section.
For Installation instructions and User Guides please visit the
User Guides
section of
the Woolich Racing web site.
For other information and frequently asked question please search the
Support Centre
and
Woolich Racing Forums.
2) Interface Description
The Interface has a two position switch to change the mode of the Interface and three
LEDs to indicate the operational status of the Interface.
Switch position (mode):
Left hand switch position is boot loader (Firmware Update) mode.
In this position all LEDs will be flashing simultaneously while in an idle state.
Right hand switch position is normal operation mode.
The green LED will be on constantly while in an idle state.
The LEDs indicate the operational status of the Interface where the actual sequence of
lighting of the LEDs will described in the relevant sections below.
3) Installing USB Drivers
1) The Interface uses standard Windows USB Drivers. You do not need to download or
install any special drivers. Windows will automatically detect the Interface when you
plug it into a computer with a USB cable. You should have the Interface switched to
normal operation mode for the initial installation.
The following window should appear confirming the device has been installed.
2) Once installed you should see the device listed in Windows “Devices and Printers” as
“Woolich Racing USB”

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin