MA-SLGP_EN.pdf

(63 KB) Pobierz
Polymer Electric
Assembly Instructions
for Safety Edges
Fitting the rubber profile to the C-rail
GP 22 / GP 39 / GP 39 L / GP 50 / GP 50 L / GP 50 OSL / GP 60 / GP 120
In 3 steps ...
1.
Liberally brush diluted washing-up liquid
onto the C-rail and the foot of the rubber
profile (GP).
brush
brush
2.
Press the first 30 - 40 cm of one side
of the rubber profile foot into the C-rail.
3.
Gradually clip in the other long side
of the GP by pressing it firmly with your
thumb or using a spatula.
Repeat these 3 steps for the next
40 - 80 cm until the entire rubber profile
is fitted to the C-rail.
Then, to check that the rubber profile is
fitted properly, press a few times along the
entire length.
WARNING!
To avoid damaging the rubber profile (GP) and Safety Element
231111
do not shorten
it by cutting it;
do not pull
the cable;
do not pull
the GP onto the C-rail;
do not bend
or
roll
the GP;
do not hammer
the GP into the C-rail with a hammer.
Mayser Polymer Electric
Postfach 30 48
89020 Ulm
Germany
Tel. +49 731 2061-0
Fax +49 731 2061-222
Polymer Electric
Assembly Instructions
for Safety Edges
Fixing the CM-rail to the closing edge
Preparation
Insert upper section of rail into lower section
of rail.
Look to check whether the rails are aligned
properly.
On each side, mark, pre-drill and drill a
borehole ( Ø 2.5 mm for M3x8 ).
Insert and tighten 2 safety screws.
• On both sides, mark and drill countersunk
holes every 50 to 80 cm (along the groove).
up
pe
ct
r se
ion
il
f ra
o
lower section of rail
Mount lower section
of rail
Remove lower section of rail from upper
section.
Place onto closing edge.
Make sure the assembly surface has no sig-
nificant bumps.
For each second or third oblong hole, mark
and drill a borehole
• Mount with countersunk or socket-head screws
up to size M5.
Mount upper section
of rail
Insert rubber profile fitted to upper section of
rail into lower section of rail.
Look to check whether the rails are aligned
properly.
Re-insert and tighten safety screws.
Insert end plug in the ends of the rail upper
section in such a way that the rail lower sec-
tion is also covered.
Further rails:
Apart from rails C 35 M and C25 M,
the rails illustrated on the left are also
available. Simply drill holes at the ar-
rows and attach them to the closing
edge
C 25 L
C 25
C 35
C 25 S
C 35 S
Mayser Polymer Electric
Postfach 30 48
89020 Ulm
Germany
Tel. +49 731 2061-0
Fax +49 731 2061-222
231111

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin