cmdlineoptions.txt

(1 KB) Pobierz
cmdline.txt
///consist only from one single text line..so no line breaks///

z2 ram:
z2_ram_size= x (x=0, 1, 2, 4 or 8)


///Slow ram: ///
enable_c0_slow 0.5 MB
enable_c0_slow enable_c8_slow 1.0 MB
enable_c0_slow enable_c8_slow enable_d0_slow 1.5 MB


///Use SLOW ram as CHIP(Uses memory in Expansion slot. Needs min. Agnus 8372A): ///
move_slow_to_chip JP2 in default position(no soldering of JP2 on the motherboard needed)


///Set amount of VIDEO memory for emu68-vc4.card driver:///
vc4.mem=16 (default). Set value to 0 to disable use of video driver


///Disable fpu:///
nofpu


///Swap df0:///
swap_df0_with_dfx (x=1,2 or 3)


///Move VBR to end of FAST ram:///
vbr_move
+ Slightly faster interrupt handling & fetching address through faster arm memory instead of slower chip ram
- Classic demos may not work


///Disable switch to 50 MHz speed on SDCARD:///
sd.low_speed


///Change speed of SDCARD clock(will not work if sd.low_speed is also used):///
sd.clock=50 (default). Value can be 50-200 MHz(>50 is overclocking).


///Set verbosity level of brcm-sdhc:///
sd.verbose=x (x=0 to 10. Default is 0) Maybe not implemented yet!


///change sd.unit0 (partition0) behaviour of brcm-sdhc.device:///
sd.unit0=ro read-only. This is the default
sd.unit0=rw read-write. Use with care!!!
sd.unit0=off hidden


///Serial debug (2 GPIO pins):///
debug disassemble async_log
(async_log option uses it's own CPU core for logging. Remove if not desirable)

921600 bps 8n1 (any ft232 should do)
Zgłoś jeśli naruszono regulamin