11281-001_Altos_ACS8000-10_User_Manual_Part_1_Feb82.pdf

(4339 KB) Pobierz
("Li:O)]
COMPUTER SYSTEMS
Computer System
ACS8000-10
User Manual
February 1982
Part Number 11281
-001
ALTOS COMPUTER SYSTEMS
ACS 81BI-ll
COMPUTER SYSTEM
USER MANUAL
CAUTION
Altos Equipment, when installed as defined
within this manual, is intended for use as a
Class A computing device subject to FCC Rules,
Part 15, Subpart
J.
The equipment is used
under temporary permit while awaiting
completion of testing for compliance with FCC
Rules.
These Rules ensure reasonable
protection from radio emissions that can
inter fer with normal reception by radio
communications devices.
Should any
interference occur, the user of this equipment
will be required to take corrective measures at
his own expense.
PREFACE
This manual is divided into two parts.
Part One presents hardware installation
procedures and diagnostics tests and
utilities. The diagnostic tests should be run
whenever the ALTOS ACS
8riHH?J-10
system is set
up or reconfigured.
Part Two presents hardware specifications and
circuit schematics for the ALTOS
8500
CPU, the
Hard Disk Controller Board, the Tape
Controller Board,
and the I/O Port
Assignments. This section does not normally
need to be consulted during initial system set
up.
The Table of Contents for Part TWo repeats
starting after Part One, page 2-34.
TABLE
or
COIDHTS
SEC'lION
'lITLE
PAU ONB
PAGE
1.
1.1
INTRODUCTION •••••••••••••••••••••••••••••••••••••
Unpacking and Installing your Computer •••••••••••
Unpacking your Computer ••••••••••••••••••••••••••
Installation and Checkout ••••••••••••••••••••••••
Console Terminal and Printer Connections •••••••••
Disk Insertion •••••••••••••••••••••••••••••••••••
Packing/Shipping •••••••••••••••••••••••••••••••••
Bringing up Computer •••••••••••••••••••••••••••••
System Power-On ••••••••••••••••••••••••••••••••••
Initial Console Display ••••••••••••••••••••••••••
System Power-Down ••••••••••••••••••••••••••••••••
Floppy Disk Drive Identification •••••••••••••••••
System Configuration •••••••••••••••••••••••••••••
Hardware Configuration Jumper Block ••••••••••••••
Software Configuration Jumper Block ••••••••••••••
Multi-User Networking Port Configuration
Jumper Block •••••••••••••••••••••••••••••••••••••
On
Hard Disk Controller ••••••••••••••••••••••••••
ALTOS DIAGNOSTIC EXECUTIVE (ADX) VERSION 2.3F ••••
Diagnostic Command Categories ••••••••••••••••••••
SETUP/FORMAT/COPY UTILITIES ••••••••••••••••••••••
ADXSETUP Utility •••••••••••••••••••••••••••••••••
FLPYFORM Utility •••••••••••••••••••••••••••••••••
BOOTCOPY Utility - One Floppy Disk Drive •••••••••
FLPY Utility •••••••••••••••••••••••••••••••••••••
SYSTEM AND FLOPPY DRIVE TESTS ••••••••••••••••••••
CPUTST85 ••• '••••••••••••••••••
~
•••••••••••••••••••
1-1
1.1.1
1.2
1.2.1
1.2.2
1.3
1.4
1.4.1
1.4.2
1.4.3
1.5
1.6
1.6.1
1.6.2
1.6.3
1.6.4
2.
1-3
1-3
1-5
1-5
1-5
1-0
1-9
1-9
1-9
1-lB
1-11
1-12
1-12
1-12
1-12
1-12
2-1
2-2
2-2
2.1
2.1.1
2.2
2.3
2.4
2.5
2.6
2.7
2.0
2.9
2.1B
2.11
2.12
2.13
2.13.1
2.13.2
2.13.3
2.13.4
2.13.5
2.13.6
2.13.7
2.13.0
2.13.9
2.13.1B
2.13.11
2.13.12
FLPYTEST utility •••••••••••••••••••••••••••••••••
PRNTEST ••••••••••••••••••••••••••••••••••••••••••
~1I~Ef)~
••••••••••••••••••••••••••••••••••••••••••
DISKSTAT •••••••••••••••••••••••••••••••••••••••••
Hard Disk Tests and Functions ••••••••••••••••••••
Hard Disk (0") Test Facility V3.4 ••••••••••••••••
Format Disk Drive ••••••••••••••••••••••••••••••••
Verify Addresses for all sectors on Disk •••••••••
Seek Test with Optional Verify •••••••••••••••••••
write Entire Disk ••••••••••••••••••••••••••••••••
Read Entire Disk •••••••••••••••••••••••••••••••••
Set Flag Byte for Specific Sector ••••••••••••••••
Hard Disk Read/Write Error Test ••••••••••••••••••
Miscellaneous Functions ••••••••••••••••••••••••••
Hard Test 9 - Copy Diagnostics to Hard Disk ••••••
Hard Test 1B
Initialize Hard Disk System Track •
Hard Test 11
Copy System to Hard Disk ••••••••••
Hard Test 12
Assign Diagnostic Area ••••••••••••
2-3
2-6
2-0
2-9
2-11
2-11
2-12
2-14
2-15
2-16
2-17
2-10
2-19
2-2B
2-21
2-22
2-23
2-25
2-26
2-29
2-31
.2-32
2-33
2-34
i
TABLE
SBCTIOR
or
COIrrEftS
TI'fl,E
PAGE
PAM'
ftO
1.
a500 CENTRAL PROCESSING UNIT PRINTED CIRCUIT BOARD
AND THE an HARD DISK CONTROLLER BOARD ••••••••••••
1-1
2.
2.1
2.2
2.3
2.4
2.5
2.6
2.7
3.
THE a500 CPU PRINTED CIRCUIT BOARD (PCB)
• • • • •
• •
Memory •••••••••••••••••••••••••••••••••••••••••••
2-1
2-1
2-1
2-1
2-3
2-3
2-10
2-11
The Hard Disk Controller (HDC) •••••••••••••••••••
Floppy Disk Controller (FDC) •••••••••••••••••••••
Magnetic Tape Unit Controller ••••••••••••••••••••
I/O Port ASSignments for the a500 PCB ••••••••••••
Za0 Interrupt Daisy Chain ••••••••••••••••••••••••
ALTOS Interface Connector Wiring •••••••••••••••••
ALTOS an HARD DISK CONTROLLER, MTU CONTROLLER, AND
THE SHUGART an SOFT-SECTORED DRIVE •••••••••••••••
an Hard Disk Controller ••••••••••••••••••••••••••
Commands/Command Ports •••••••••••••••••••••••••••
status/status Port •••••••••••••••••••••••••••••••
Ports 022H, 020H and 02lH ••••••••••••••••••••••••
Forma
t
ting •••••••••••••••••••••••••••••••••••••••
Reading or Writing a Sector ••••••••••••••••••••••
Reading a Sector •••••••••••••••••••••••••••••••••
Writing a Sector •••••••••••••••••••••••••••••••••
Controller Responses •••••••••••••••••••••••••••••
Shugart an Soft-Sectored Drive •••.••••••••••••••••
Magnetic Tape Controller •••••••••••••••••••••••••
3-1
3-1
3-6
3-7
3-10
3-11
3-13
3-13
3-14
3-15
3-15
3-17
3.1
3.1.1
3.1.2
3.1.3
3.2
3.3
3.3.1
3.3.2
3.4
3.5
3.6
SCBIlUICS
a500 CPU PCB SCHEMATICS
an HARD DISK CONTROLLER SCHEMATICS
XENTEK 6055 POWER SUPPLY SCHEMATICS
REAR PANEL I/O PCB SCHEMATIC
SHUGART SCHEMATICS
ii
Zgłoś jeśli naruszono regulamin