RM-208 Light SWAP engine version 2.pdf

(65 KB) Pobierz
CONFIDENTIAL
1 (2)
Customer and Market Operations
EMEA Customer Care
Service Bulletin No. SB-007/08.06.07
RM-208
RM-208 LIGHT SWAP ENGINE
Version history:
Version 2 08.06.07
Version 1 10.04.07
CCT/ITEM reference corrected (I0205 -> I0208)
Initial version
In a case of the RM-208 where engine board is beyond economical repair
(BER) there is swap engine replacement for that.
Product name: E65-1 RM-208 Light Swap Engine
Kit Code: please ref RM-208 SB-003
Reporting:
Note: BE claims with SWAP transceivers are not accepted anymore.
Only MS claims with light SWAPs are accepted.
-
-
-
-
Level 1
Service Activity Code: MS
CCT/ITEM reference:
I0208
(LIGHT SWAP ENGINE MODULE)
Fault Code: N/A (Individual, depending on the root cause of the failure)
Symptom Code: N/A (Individual, depending on the root cause of the
failure)
Level 2
x
Level 3
x
Level 4
Version 2
RM-208 SB-007
Copyright © Nokia Corporation 2007
CONFIDENTIAL
2 (2)
Special Equipment needed:
-
-
-
-
-
An other phone having Bluetooth (BT) and Infrared (IrDa) interface
Nokia charger (AC-4) with 2 mm plug
Compatible Nokia or generic headphones
Compatible Micro SD card
SB-7 WLAN test box
Procedure:
Although the light SWAP engine is tested and tuned in production phase,
additional UI and call tests are necessary to verify full device functionality.
Before proceeding with these phone specific test steps following general
procedure has to be carried out.
-
-
-
After product is completely assembled, it has to be updated according to
the original product code of the faulty unit.
To check the functionality of the phone, perform Final Test corresponding
to General SB-201 (Final
Test Specification for GSM/WCDMA Phones).
In addition to Final Test (described in General SB-201) below mentioned
product specific functions must be tested appropriately.
Test steps:
Cameras:
-
Check the functionality of the camera
Slide:
-
Check slide functionality by opening the slide normally
Memory card:
-
Insert memory card and test that it is recognized
BT & WLAN
-
-
Switch BT on and send a file to reference phone
For RM-208 use SB-7 to test WLAN functionality
Ambient Light Sensor (ALS):
-
Re-tune ALS as instructed in product specific service manual
Level 1
Level 2
x
Level 3
x
Level 4
Version 2
RM-208 SB-007
Copyright © Nokia Corporation 2007

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin