AUA303GBD.PDF

(36 KB) Pobierz
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS
www.cobra.it
REV. 00
PETROL
DIESEL
MAKE
ALARM/SIREN
POSITION
AUDI
MOD.
A3
YEAR
03
→
X
Position the compact alarms and the sirens on the support near the locking of the bonnet.
CENTRAL UNIT POSITION
POWER SUPPLY
Position the modular sistems and the modules under the central tunnel or under the
passenger’s side seat.
+30:
connect directly to the positive pole of the battery.
-31:
connect directly to the ground terminal located behind the driver’s side sill cover.
+15/54:
connect to the 2 mm
2
BLACK wire, in the wiring harness coming out of the fuse box
located on the left side of the dashboard.
Connect to the BLACK/WHITE wire at the position nr. 11 and to the BLACK/GREEN wire at
the position nr. 9 located in the 21 way light brown connector, marked “D”; BLACK/GREEN
wire at the position nr.10 in the black connector marked “B”; BLACK/WHITE wire at the
position nr.11 in the light brown connector, marked “C” and to the BLACK/WHITE wire at the
position nr.8 and to the BLACK/GREEN wire at the position nr.6, in the 12 way black
connector, marked “A”. To make the connection it is necessary to separate the lines by means
of diodes.
IGNITION WIRE
DIRECTION INDICATORS
CENTRAL DOORS LOCKING Negative control signal
Connect with both unlock and lock wires (VIOLET and ORANGE) of the antitheft and to the
BLUE/WHITE wire, at the position nr.13, in the 20 way black connector, directly inside the
driver’s side door. As alternative, you can find the same wires in the wiring harness coming out
of the central locking motor of the central locking unit, inside the driver’s side door.
Note:
it is necessary to insert a 180 Ohm resistance in serie to the ORANGE wire of the
antitheft. Refer to the
fitting diagram nr.200.
IMMOBILISATION POINT
Gasoil pump
Cut the 1 mm
2
BLUE/BLACK wire at the position nr.27, behind the fuse box.
+50:
Cut the 0,35 mm
2
RED/BLACK wire, at the position nr.1, in the 12 way black connector,
marked “G”, in the central located under the driver’s side dashboard.
Connect to the BROWN/LIGHT BLUE wire, in the wiring harness coming out of the bonnet
lamp.
Connect to the BROWN/WHITE wire in the wiring harness behind the lateral bulkhead, driver’s
side.
Connect to the BLACK/RED wire, at the position nr.8, in the wiring harness coming out of the
17 way light brown connector, in the central located in the rear covering of the passenger’s
side boot.
STARTER
BONNET SWITCH
DOORS SWITCH
BOOT SWITCH
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
aua303gbd.doc
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS
www.cobra.it
REV. 00
FITTING DIAGRAM NR. 200
Diagram to connect the diode to make central unlock and lock on
AUDI A3
year 2003
ORANGE
VIOLET
ORANGE/WHITE
VIOLET/WHITE
180 Ohm resistance
ground
Driver’s side door
switch
1N4004 diode
Towards the central
BLUE/WHITE at the position nr.13, in the 20 way black connector of the central
of the windows activating central, directly inside the driver’s side door.
ground
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
aua303gbd.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin