OPFRO00GBD.PDF

(10 KB) Pobierz
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS
www.cobra.it
REV. 00
PETROL
DIESEL
MAKE
ALARM/SIREN
POSITION
OPEL
MOD.
FRONTERA
YEAR
00
→
X
Position the compact alarms and the sirens in the engine compartment, near the driver’s
side headlamp.
Position the modular systems and the modules under the left side of the dashboard, driver’s
side.
+ 30:
connect to the general power supply located in a multiway connector at the entrance
of the fuse box.
- 31:
connect with a cable terminal directly to the car body.
+ 15/54:
connect to the LIGHT BLUE/BLACK wire located in the 13 way connector near the
steering column.
Connect to the GREEN/WHITE and GREEN/BLACK wires located in the 13 way connector
near the steering column.
Positive control signal
Front window, driver’s side:
cut the BROWN/RED wire located in the wiring harness coming out of
control switch.
Front window, passenger’s side:
cut the BROWN/RED wire located in the wiring harness coming out of the
control switch.
Rear window, driver’s side:
cut the BROWN/RED wire located in the wiring harness coming out of
control switch.
Rear window, passenger’s side:
cut the BROWN/RED wire located in the wiring harness coming out of the
control switch.
The above connections must be done inside of each door.
CENTRAL UNIT POSITION
POWER SUPPLY
IGNITION WIRE
DIRECTION INDICATORS
ELECTRIC WINDOWS
the driver’s side
passenger’s side
the driver’s side
passenger’s side
CENTRAL DOORS LOCKING
Negative control signal
Connect to the GREEN/RED wire (lock) and to the RED/BLUE wire (unlock) located in the
wiring harness coming out of the driver’s side door.
Gasoil pump
If the vehicle has the inertial switch, it is suggested to interrupt one of the two wires coming
out of the same.
+ 50:
Cut the BLACK/WHITE wire located in the 13 way white connector, under the driver’s
side dashboard, on the left of the steering column.
Install an additional switch on the headlamp support plate, near the original bonnet bumper
rubber.
Connect to the BLACK/WHITE wire located in the wiring harness coming out of the central
doors locking unit on the rear of the glove compartment, passenger’s side.
Connect to the wire located in the wiring harness coming out of the boot lamp.
IMMOBILISATION POINT
STARTER
BONNET SWITCH
DOORS SWITCH
BOOT SWITCH
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
opfro00gbd.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin